Problem connecting 2 arduinos with CAN BUS - Networking, Protocols, and Devices - Arduino Forum

Hi everyone, I started a project where I need to connect 2 Arduino with CAN-BUS protocol. For this I went to the simplest and tried to make ONLY the communication via CAN bus of the 2 Arduino with a simple example I found in the library that you can download directly from Arduino called: "CAN_BUS_Shield-master". As known, there are 2 codes (1 for the transmitter and 1 for the receiver), the transmitter one works just fine (I think). The problem comes in the receiver code, when it checks if data

RS-485 communication on multiple Arduino boards - Networking, Protocols, and Devices - Arduino Forum

20 Tutorial: Multiple Devices on One Arduino I2C Bus

arduino - RS485 not working - Electrical Engineering Stack Exchange

Connect Two Arduino Boards Using I2C Communication Protocol

i2c Arduino: how to create network, parameters and address scanner – Renzo Mischianti

Two Arduinos talking via Bluetooth - Networking, Protocols, and Devices - Arduino Forum

CAN Bus Messages - Networking, Protocols, and Devices - Arduino Forum

Connecting multiple Arduinos with the exact same code - Project Guidance - Arduino Forum

Controller Area Network (CAN Bus) Prototyping With the Arduino Uno

Common Communication Peripherals on the Arduino: UART, I2C, and SPI, Arduino

MCP2515 CAN-BUS Arduino Tutorial - Getting started, Interfacing, Applications - Latest Open Tech From Seeed

How to Setup I2C Communication on the Arduino - Circuit Basics

💬 Building a wired RS485 sensor network

Problems receiving GPS-RTK data on an Arduino Due through the i2c bus - Networking, Protocols, and Devices - Arduino Forum